Unsinkable Olympic-Class Passenger Liner Sinks

Spread the love

On April 14, 1912, the RMS Titanic hit an iceberg in the North Atlantic. In less than three hours, the unsinkable ship sank to the bottom of the sea. A total of more than 1,500 lives were lost.i-31c24175eec6f6dc60094f86fc2c1b67-Titanic-lifeboat.gifThe events surrounding the sinking of the Titanic may be more of a reflection of human social ineptitude (to put it kindly) than technological hubris.

Of a total of 2,223 people, only 706 survived; 1,517 perished.[8] The majority of deaths were caused by victims succumbing to hypothermia in the 28 °F (â??2 °C) water. Only two of the 18 launched lifeboats rescued people out of the water after the ship sank. Lifeboat 4 was close by and picked up five people, two of whom later died. Close to an hour later Lifeboat 14 went back and rescued four people one of which died afterwards. Other people managed to climb onto the lifeboats that floated off the deck. There were some arguments in some of the other lifeboats about going back, but many survivors were afraid of being swamped by people trying to climb into the lifeboat or getting pulled down by the suction from the sinking Titanic, though it turned out that there had been very little suction. *

Why did the titanic sink? Turns out it was a bad rivet. Oh, and an iceberg…National Geographic: Titanic Seconds from Disaster in Six Parts:

Have you read the breakthrough novel of the year? When you are done with that, try:

In Search of Sungudogo by Greg Laden, now in Kindle or Paperback
*Please note:
Links to books and other items on this page and elsewhere on Greg Ladens' blog may send you to Amazon, where I am a registered affiliate. As an Amazon Associate I earn from qualifying purchases, which helps to fund this site.

Spread the love

3 thoughts on “Unsinkable Olympic-Class Passenger Liner Sinks

  1. wasn’t there a problem with high sulfur content in the steel that had left it overly brittle? I wish I could remember where I read the article about the questionable metallurgy of the Titanic’s hull.

  2. Both: yes. There was a lot of slag in the rivets and the plates were of dubious quality. My last ‘command’ was refitted at Harland and Wolff in Belfast and it was with some trepidation I sailed her. (Rightly so: their delicate attentions left my boat’s propshaft bent.)

Leave a Reply

Your email address will not be published. Required fields are marked *